* sunxi-6.18: make the mess even worse
* fixing one of megis patches and add sunxi 32bit to the mess
* rewrite against 6.18
* fix media-ov5640-Don-t-powerup-the-sensor-during-driver-probe.patch
* fix media-sun6i-csi-implement-vidioc_enum_framesizes.patch
* fix misc-modem-power-Power-manager-for-modems.patch
* Fix usb-gadget-Fix-dangling-pointer-in-netdev-private-data.patch, include rewrite
* fix mmc-sunxi-mmc-Remove-runtime-PM.patch, two hunks no longer apply
* re-extract all of megis patches
* remove unneeded branch
* add note to disabled patch
* auto-generated, out of date
* drop megous drm patches in favor of Jernej's work. disable broken patches
* disable patch which breaks compilation for armhf
* disable breaking patch, rewrite everything
* remove patches unrelated to sunxi family
* fix spi dev compatible patch
* fix tsc2007 patch
* drop mainlined patch, adjust x96 mate T95 eth sd card hack
* remove upstreamed patch
* re-enable no longer broken
* another rewrite to align stuff properly
* adjust various comments in series.conf
* recover lost overlays
* uew5622: fix compilation against Linux 6.18
* fix Add-sunxi-addr-driver-Used-to-fix-uwe5622-bluetooth-MAC-address.patch
* adjust patch subject to make sense
* restore fixup creation
restore overlay prefix on opiz2
this needs to be properly sorted at some point
* bump to 6.18.1
sunxi and sunxi64 build just fine
* fix and re-enable drv-mfd-axp20x-add-sysfs-interface.patch
* rewrite patches
6.6-stable commit 4e83377 is not easily mergeable with hardkernel 0cd454a
and it is not clear whether the memleak it fixes occurs with the
hardkernel code at all. As such, drop it entirely.
- Add mainline U-Boot support for edge branch (v2026.01-rc2)
- Add U-Boot defconfig patch for nanopi-r76s
- Fix USB3.0 Type-A host port configuration in DTS
- Enable USB OTG0 controller in host mode with power GPIO control
- Set KERNEL_TEST_TARGET to edge
- from linux-t2 project: https://github.com/t2linux/linux-t2-patches
- https://t2linux.org/
- x86: add .config hook `custom_kernel_config__applet2()`
- original patches from t2linux for 6.18 and 6.12
- rewrite patches against v6.18-rc4 and v6.12.57
- `7001-drm-i915-fbdev-Discard-BIOS-framebuffers-exceeding-h.patch`
needed special attention for correct patch attribution (missing From)
- `1002-Put-apple-bce-in-drivers-staging` needs reordering to the
top to avoid conflicts with EXTRAWIFI sed-based "patching"
- Change debug console from ttyS2 to ttyS0
- Remove SERIALCON from board configs
- Set console based on BOOT_SOC
- Enable UART0 in device tree for nanopi-r76s
Initial support for ODROID M1S
Tested with Debian Bookworm and Noble Cinnamon and Noble GNOME desktop
environment.
See: https://forum.armbian.com/topic/33242-odroid-m1s-image-planned/
- few fixes, rebase
Signed-off-by: Ricardo Pardini <ricardo@pardini.net>
Co-authored-by: Ricardo Pardini <ricardo@pardini.net>
