In sunxi-6.1 and sunxi-6.5 kernel we have a patch that changes r_rsb to r_i2c. But same
change is not done for u-boot. Mixing use of r_rsb and r_i2c seems to cause issues if
its also something handled in crust. Hence making it consistent across u-boot and kernel
dts files
After we bumped u-boot to version v2022.10, a couple of boards
stopped booting because the CONFIG_SPL_STACK value used in our
u-boot config was too low for that SOC. This change drops explicit
CONFIG_SPL_STACK defination from the affected boards.
The boards confirmed to have the issues were Orange Pi 3 LTS and
NanoPi Neo Black2 but I suspect that NanoPi K1 plus is also affected
hence similar change is done for that as well
* Add support for Recore
Signed-off-by: Elias Bakken <elias@iagent.no>
* Add board maintainter to boad config
Signed-off-by: Elias Bakken <elias@iagent.no>
---------
Signed-off-by: Elias Bakken <elias@iagent.no>
- `sunxi_common`: don't overwrite `BOOTPATCHDIR` if it is set by the board (default, but do not overwrite)
- hammer `allwinner-h616-GPU-enable-hack.patch`
* Bugfix - Bananapi PRO seems to work fine with latest u-boot
Done many reboots and it didn't break. The same has to be tested with other A20 boards
* Set Allwinner 32bit hw to most recent u-boot 2021.07
* Let's move all to 2021.07 and test ...
* remove obsolete and broken patch for pine64so u-boot
This prevents the image from being built.
Signed-off-by: Icenowy Zheng <icenowy@aosc.io>
* sunxi: fix pine64so phy-mode and add yt8511 support
Pine A64-LTS board should have RGMII-TXID mode instead of RGMII-ID (the
Realtek PHY chip's RXID is sometimes broken).
In addition, new Pine A64-LTS v2 board will use YT8511 instead of
RTL8211E, which still works under RGMII-TXID mode.
Backport YT8511 driver and phy-mode change from linux-next.
Signed-off-by: Icenowy Zheng <icenowy@aosc.io>
Co-authored-by: Igor Pečovnik <igorpecovnik@users.noreply.github.com>
* Remove unnecessary patch
- this patch works when compiling and installing manually.
- the dtb with the changes is taken from the kernel and not from u-boot, therefore this patch does not work.
* Add enable-audio-codec-bpim2ultra-kernel.patch
- Add patch to enable audio codec in bpi-m2-ultra with h3 compatible
- Built and tested on Armbian Buster with Kernel 5.11.x (edge)
* Remove unnecessary patch
- this patch works when compiling and installing manually.
- the dtb with the changes is taken from the kernel and not from u-boot, therefore this patch does not work.
* Add enable-sound-pinecube-kernel.patch
- Add patch to enable audio codec in pinecube with v3s compatible
- Built and tested on Armbian Buster with Kernel 5.11.x (edge)
