* Move default values where they should be and fix for updates not showing up
* Add support for vnstat and ZFS
* Cosmetical
* Put defaults back
* Update data displaying
* Add support for displaying "reboot required" when regular packages like e.g. dbus requires a reboot
* Add dependency problem check
* Also add storage to user defaults
If kernel is build with GCC9.2 we can't compile modules with DKMS. Reverting compiler to 8.3 until better solution emerges. No known side effects. Tested - working.
https://armbian.atlassian.net/browse/AR-557
The mainline kernel is filling up logs about the ttyS0, it should be ttyaml0 on mainline as is inherited from meson64_common.inc, only overridden in case of legacy kernel.
Some of these get applied at wrong offsets or have fuzz. Fix.
Remove patch 93. It's already upstream. It also has other fixes applied
to it.
Signed-off-by: Rosen Penev <rosenp@gmail.com>
* sunxi: kernel: current/dev: enable sun6i-csi and disable LL debug on UART0
The former is useful on some boards, e.g. PineCube.
The latter blocks boards that do not utilize UART0 from booting.
Signed-off-by: Icenowy Zheng <icenowy@aosc.io>
* sunxi: add new family sun8i-v3s
This family is intended for boards with V3/V3s/S3/S3L chips and low
DRAM capacity.
Signed-off-by: Icenowy Zheng <icenowy@aosc.io>
* sunxi: add PineCube board
This board features Sochip S3 SoC (Allwinner V3 die + co-packaged 128MiB
DRAM), and an OmniVision OV5640 camera is shipped with the board.
Add support for it. It could be used as an IP camera then.
Kernel support is only added to current/dev branch, with dev just using
mainline-merged DT and current using backported DT from 5.10-rc.
Signed-off-by: Icenowy Zheng <icenowy@aosc.io>
* sunxi: kernel: current/dev: add V3s OHCI/EHCI nodes
These are needed for USB host on V3s boards to work.
Signed-off-by: Icenowy Zheng <icenowy@aosc.io>
* update fancontrol configuration
* Enable network activity led, default to eth0
* Do not disable auto poweron on power loss event
* Added UPS timer
Provide timer to poweroff system after 600 s (10 minutes) of power loss
event. If power restored within that time window, cancel the timer.
* Use different service for legacy
LK 4.4 does not have ledtrig-netdev, so it will cause the service to
fail.
* Use 10m instead 600 seconds in UPS timer
Systemd time can use m suffix for minutes. Use this to make it easier to
read.
