* sunxi-6.18: make the mess even worse
* fixing one of megis patches and add sunxi 32bit to the mess
* rewrite against 6.18
* fix media-ov5640-Don-t-powerup-the-sensor-during-driver-probe.patch
* fix media-sun6i-csi-implement-vidioc_enum_framesizes.patch
* fix misc-modem-power-Power-manager-for-modems.patch
* Fix usb-gadget-Fix-dangling-pointer-in-netdev-private-data.patch, include rewrite
* fix mmc-sunxi-mmc-Remove-runtime-PM.patch, two hunks no longer apply
* re-extract all of megis patches
* remove unneeded branch
* add note to disabled patch
* auto-generated, out of date
* drop megous drm patches in favor of Jernej's work. disable broken patches
* disable patch which breaks compilation for armhf
* disable breaking patch, rewrite everything
* remove patches unrelated to sunxi family
* fix spi dev compatible patch
* fix tsc2007 patch
* drop mainlined patch, adjust x96 mate T95 eth sd card hack
* remove upstreamed patch
* re-enable no longer broken
* another rewrite to align stuff properly
* adjust various comments in series.conf
* recover lost overlays
* uew5622: fix compilation against Linux 6.18
* fix Add-sunxi-addr-driver-Used-to-fix-uwe5622-bluetooth-MAC-address.patch
* adjust patch subject to make sense
* restore fixup creation
restore overlay prefix on opiz2
this needs to be properly sorted at some point
* bump to 6.18.1
sunxi and sunxi64 build just fine
* fix and re-enable drv-mfd-axp20x-add-sysfs-interface.patch
* rewrite patches
- from linux-t2 project: https://github.com/t2linux/linux-t2-patches
- https://t2linux.org/
- x86: add .config hook `custom_kernel_config__applet2()`
- original patches from t2linux for 6.18 and 6.12
- rewrite patches against v6.18-rc4 and v6.12.57
- `7001-drm-i915-fbdev-Discard-BIOS-framebuffers-exceeding-h.patch`
needed special attention for correct patch attribution (missing From)
- `1002-Put-apple-bce-in-drivers-staging` needs reordering to the
top to avoid conflicts with EXTRAWIFI sed-based "patching"
- Change debug console from ttyS2 to ttyS0
- Remove SERIALCON from board configs
- Set console based on BOOT_SOC
- Enable UART0 in device tree for nanopi-r76s
Instead of using the TI k3.conf and overriding configuration, add a new
config for BeagleBoard.org Linux and U-Boot and use it for the boards
that use that Linux/U-Boot.
Signed-off-by: Andrew Davis <afd@ti.com>
Vendors using TI K3 devices may use kernels downstream from the TI vendor
kernel and U-Boot. To make this easier factor out from k3.conf all other
configuration that would be common to any kernel and U-Boot used.
Signed-off-by: Andrew Davis <afd@ti.com>
- call_extensions_kernel_config() now declares the vars and calls
armbian_kernel_config_apply_opts_from_arrays() at the end
- so each individual hook doesn't need to
- adapt family code using the old way too
Users request: Failed apt dist-upgrade from the trixie xfce image downloaded using rpi-imager. The boot partition is only 256M so it get full and the update fail blowing up everything. Please consider using 512 Mb boot partitions. Thanks
