- works pretty nice (albeit no USB support in kernel, only u-boot)
- this is still `WiP`: once Kwiboo lands his rk3528 patchset,
most of this will change / be much simpler. Just be patient!
- Important: the Realtek DSA switch chip is not really understood
by the likes of NetworkManager and systemd-networkd; they'll think
the board has 4 ethernet interfaces, which is not really true.
Only one real MAC address (the SoC's GMAC) exists; in front of it
is a programmable switch; to make it work one needs custom setup
to bridge the LANx ports and keep WAN separate. Even then, the
WAN port will have the same MAC as LANx and needs to be really
used on a separate physical network, otherwise chaos/conflicts.
For simple usage/testing, I recommend to connect only LAN1 and
disable the other ports in NetworkManager after the first boot.
- Note: `edge` u-boot can be written to MTD/SPI-FLASH and works.
But keep in mind it _cannot_ boot the vendor kernel (it hangs
during pcie init); might work when booting from SD, if pcie is
not enumerated by u-boot.
- works: PCIe/NVMe, GMAC, Realtek DSA switch, SD, SPI-NOR
- does not work: USB (I didn't manage to pick correctly; lets wait for Kwiboo on this)
- untested: everything else
- the gmac works, but is connected to switch chip that is not supported by u-boot
- here I disable gmac1 for the u-boot DT
- that allows for easier booting from USB ethernet adapters
* sunxi-6.18: make the mess even worse
* fixing one of megis patches and add sunxi 32bit to the mess
* rewrite against 6.18
* fix media-ov5640-Don-t-powerup-the-sensor-during-driver-probe.patch
* fix media-sun6i-csi-implement-vidioc_enum_framesizes.patch
* fix misc-modem-power-Power-manager-for-modems.patch
* Fix usb-gadget-Fix-dangling-pointer-in-netdev-private-data.patch, include rewrite
* fix mmc-sunxi-mmc-Remove-runtime-PM.patch, two hunks no longer apply
* re-extract all of megis patches
* remove unneeded branch
* add note to disabled patch
* auto-generated, out of date
* drop megous drm patches in favor of Jernej's work. disable broken patches
* disable patch which breaks compilation for armhf
* disable breaking patch, rewrite everything
* remove patches unrelated to sunxi family
* fix spi dev compatible patch
* fix tsc2007 patch
* drop mainlined patch, adjust x96 mate T95 eth sd card hack
* remove upstreamed patch
* re-enable no longer broken
* another rewrite to align stuff properly
* adjust various comments in series.conf
* recover lost overlays
* uew5622: fix compilation against Linux 6.18
* fix Add-sunxi-addr-driver-Used-to-fix-uwe5622-bluetooth-MAC-address.patch
* adjust patch subject to make sense
* restore fixup creation
restore overlay prefix on opiz2
this needs to be properly sorted at some point
* bump to 6.18.1
sunxi and sunxi64 build just fine
* fix and re-enable drv-mfd-axp20x-add-sysfs-interface.patch
* rewrite patches
