ATF compilation stops with make: *** No rule to make target 'drivers/allwinner/i2c/sunxi_i2c.c', needed by 'build/sun50i_h6/debug/bl31/sunxi_i2c.o'. Stop.
Reason for disabling Realtek 8822 SDIO Wifi driver: https://github.com/rockchip-linux/kernel/issues/114
GCC 7 (with -Wmisleading-indentation) discovered programming mistakes in Realtek SDIO Wifi drivers. As these drivers are not really required for Rockchip64 devices, building them for default Linux kernel has been disabled until Realtek provides fixed drivers.
* Bump to 4.18, removing the obvious, fixing build problems, put some on waiting.
* Pin 4.18 to DEV, rollback 4.14 to NEXT, adjust configs, remove one deprecated patch from NEXT and add board-h3-address-some-stability-issues.patch
* Adjust few boards in development to new reality, removing it from NEXT for now
* Adjust few board configs
* Board config adjustement
* Adjust few boards configs
* Port NeoCore2 and Neo21.1 to 4.14.y
* Adjust board config
* Adjust board config
Based on work of David Huang https://github.com/hjc4869 Changed in the transition:
- firefly family was renamed to rk3399, which we actually never started to use. It was made for Odroid N1, which will never be sold
- adjusted compiler toolchain2 parameter
- added standard wireless drivers
- kernel config with the following changes: Docker dependencies, ZRAM, CPUfreq info, ...
- added upstream patches
- made test Ubuntu Bionic desktop and CLI Stretch build, bootlog: http://ix.io/1jVu
TBD: wifi and BT support, mainline kernel, ...
* [Early WIP] Update sunxi-next to kernel 4.17
* Switch Allwinner 32 and 64bit to U-boot 2018.05
* Adjust patched for 4.17.y / sunxi-next
- adjust both configurations
- removing FAT support from u-boot (breaks if you try to save)
Tested those boards:
Cubietruck: wlan fails http://ix.io/1fYS USB OK, HDMI yes
Bananapi R40: http://ix.io/1fZm USB OK, HDMI yes
Lime A64: USB no, HDMI no, wireless buggy, eMMC yes
Orangepi prime H5: OK http://ix.io/1fZJ DVFS no
Orangepi2e: DVFS OK, HDMI OK, net OK, wifi OK, eMMC ok, http://ix.io/1fZT
* Kernel config update, enabling HDMI on CT+
* Trying to fix A64 HDMI but failed. Fixed M64 ethernet instead
* Update orangepioneplus.wip
* Update orangepioneplus.wip
* Fix H6 build process
* Add regulator bits for Orangepizero+, thanks to @5kft
* add H5 support for optional 1.3v regulator and 1.3GHz operation
This patch adds two optional overlays that can be used to:
1) enable the 1.1v/1.3v regulator on boards that provide the necessary compatible H/W support
2) modify the default CPU clock operating table to add new 1.2GHz and 1.3GHz clocks
Note that the generated regulator overlay will only support boards whose 1.1v/1.3v regulator
is controlled by GPIO PL6.
* updates for the NanoPi NEO Plus2
This change introduces a patch that provides two changes for the NanoPi NEO Plus2:
* Configure the "cpu0" to use the "vdd_cpux" regulator; this enables the ability to use higher CPU clocks
* Correct the configurations of the on-board power and status LEDs
* Adjust nightly building and few boards config cleanup
