- rockchip64-6.19: mainline kernel (edge/6.19):
- most stuff works, incl 4G modem, NPU, RS-485, RS-232, HDMI-RX
- except:
- type-c (fusb302, I've no schematics nor will to reverse)
- DisplayPort (I don't have test hardware)
- Analog Audio (ditto)
- keep vendor u-boot for vendor branch
- mainline u-boot v2026.01:
- same DT as edge kernel, save for NPU nodes
- boot order: NVMe -> SATA -> USB -> eMMC -> Ethernet/PXE
- stable MAC addresses for GMAC0/1 via DT aliases (confirm with logging patch)
This commit enables generation of `u-boot-rockchip-spi-sata.bin`.
Flashing this to SPI flash enables U-Boot to communicate with an
attached SATA m.2 SSD, thereby allowing booting directly from SPI flash
to SATA SSD.
Kwiboo's `rk3506` branch is WIP / rebased often. Pin to commit hash while upstreaming work is underway.
Also revert (broken) changes that attempted to keep up with this branch.
For "reasons" extlinux provides a more stable boot.
Remove aw859a-wifi.service:
The service modprobes sprdwl_ng later in the boot process. Which
is not required. Just enabling it in modules-load.d will suffice.
I believe the reasoning for this service was to prevent a crash
which occurs if sprdwl_ng loads before cpufreq_dt. To prevent
the crash we will set in the defconfig CONFIG_CPUFREQ_DT=y.
Signed-off-by: Patrick Yavitz <pyavitz@gmail.com>
* Jetson Nano: retire automatic images generation - they don't work
* Cubox-i: move it to the EOS as it doesn't boot anymore and since old.
* Odroid M2: promote the board to standard support
* Orangepi3 LTS: Promote back to the supported list
- tested on actual hardware
- small fixes for:
- LEDs (new names; was wrong also in v2025.10 and previous)
- remove duplicate enablement of CONFIG_CMD_USB_MASS_STORAGE
- comment about lower USB3 port not working due share with OTG/UMS
micro-usb port that is enabled
- Change BOOTCONFIG from rk3506b to rk3506j variant
- Update btrfs patch to target correct defconfig
- Add OPTEE image support for secure boot functionality
- mainline AT-F only for non-vendor BRANCH
- vendor branch uses vendor u-boot with rkbin blobs
- sorry for the confusion; I overlooked the conditional here
- Fixes: f45765e510
- LWIP has issues with TFTP (serverip/tftpserverip) on v2026.01
- Kwiboo is already sending fixes, few separate series; check v2026.04 one day
- for now just disable the 2 boards I had enabled it for and use the legacy network stack again
- Fixes: 332e43bc8c
- Fixes: d88d32b248
- use LWIP for networking
- enable some USB network drivers
- drop (now-default) kaslrseed as it was redundant
- add gpio expander support (for "red" LED)
- flash leds once on preboot (incl red one)
- Use SERIALCON instead of systemd override for serial console
- Remove fdtfile from bootenv (use BOOT_FDT_FILE instead)
- Remove ATF_COMPILER (arm64 default)
- Inline OPTEE variables into fetch_sources_tools hook
- Remove empty family_tweaks() and family_tweaks_bsp()
- Use only debug mode for ATF build
- Build fiptool in atf_custom_postprocess
- Move header creation inline into uboot_custom_postprocess
- Use <<- heredoc for Python script
