This should be a long-term solution to armbian/community#39.
Adds a rockchip64 BOOT_SCENARIO for binman with mainline ATF and puts it
to use for the rock4-se board config.
Tested on my hardware, boots successfully.
* feat(board/orangepi5pro): Update U-Boot to v2025.07 for eMMC support
Updated the U-Boot patch from v2024.04 to v2025.07, this change
finally enables booting from eMMC on the Orange Pi 5 Pro.
The device tree source for the board has also been refactored to
support the new U-Boot version and clean up peripheral definitions.
* orangepi5pro: dts: Fix incorrect GRF node name
The GRF node was misspelled as 'sysgrf' instead
of the correct 'sys_grf'.
This commit corrects the phandle to the proper value.
Updated the U-Boot patch from v2024.04 to v2025.07, this change
finally enables booting from eMMC on the Orange Pi 5 Pro.
The device tree source for the board has also been refactored to
support the new U-Boot version and clean up peripheral definitions.
Setting MODULES="" overrides any module list inherited from the family
configuration; this may unintentionally lose essential vendor-kernel modules
(e.g. rockchip-rga, fusb302, etc.).
- Using RT kernel is a common thing on pocketbeagle 2. So add current-rt
branch similar to what is being done for the base k3 family.
Signed-off-by: Ayush Singh <ayush@beagleboard.org>
* Add initial support for Orangepi 5 Pro
Tested and Working:
Wireless & Bluetooth
USB 2.0 + USB 3.1
HDMI 2.1
Gigabit Ethernet (PCIe to RJ45 - Need drivers YT6801)
NVMe PCIe 2.0
MicroSD
Audio Controller es8388 - Audio Out
FAN PWM
LEDs PWM
Not Working:
Onboard Microphone
HDMI 2.0 (DP-HDMI - rockchip,rk3588-dp No Driver)
Not Tested:
Camera 1,2
eMMC
* OPi 5 Pro: Ethernet Driver Installation on First Boot
Implemented a simple script to install the driver
during first boot using the installation headers
included in the image. Takes just a few seconds
on first boot.
Disclaimer: Attempted installation in a chroot env but failed.
* fix: Make first-boot Ethernet driver install more robust
The `eth-driver-firstboot.service` would sometimes fail on first boot with a "Resource temporarily unavailable" error. This happened when another process had a lock on `dpkg`.
To fix this, the installation script now waits for any `dpkg` locks to be released before attempting to install the driver package. It also includes a retry mechanism (3 attempts) in case of a transient failure.
This ensures the network driver is successfully installed, providing a better out-of-box experience.
- The edge branch will soon move to 6.16, so adding the current branch
now.
- The kernel config is just a copy of edge config since both kernels are
the same right now.
Signed-off-by: Ayush Singh <ayush@beagleboard.org>
- Enable USB serial by default.
- Allows serial access without needing extra UART cable.
- Also USB serial is much faster than using the UART debug port.
Signed-off-by: Ayush Singh <ayush@beagleboard.org>
