* Use RTC to set system clock on boot
Enable kernel use of RTC to set system clock early in boot
* Use RTC to set system clock on boot
Enable kernel use of RTC to set system clock early in boot
* Use RTC to set system clock on boot
Enable kernel use of RTC to set system clock early in boot
* Bump to 4.18, removing the obvious, fixing build problems, put some on waiting.
* Pin 4.18 to DEV, rollback 4.14 to NEXT, adjust configs, remove one deprecated patch from NEXT and add board-h3-address-some-stability-issues.patch
* Adjust few boards in development to new reality, removing it from NEXT for now
* Adjust few board configs
* Board config adjustement
* Adjust few boards configs
* Port NeoCore2 and Neo21.1 to 4.14.y
* Adjust board config
* Adjust board config
enable the MTD SPI flash configuration in the sunxi-next kernel; this allows on-board
SPI flash to be available via MTD by default when enabling the "spi-jedec-nor" overlay
in the boot configuration.
* [Early WIP] Update sunxi-next to kernel 4.17
* Switch Allwinner 32 and 64bit to U-boot 2018.05
* Adjust patched for 4.17.y / sunxi-next
- adjust both configurations
- removing FAT support from u-boot (breaks if you try to save)
Tested those boards:
Cubietruck: wlan fails http://ix.io/1fYS USB OK, HDMI yes
Bananapi R40: http://ix.io/1fZm USB OK, HDMI yes
Lime A64: USB no, HDMI no, wireless buggy, eMMC yes
Orangepi prime H5: OK http://ix.io/1fZJ DVFS no
Orangepi2e: DVFS OK, HDMI OK, net OK, wifi OK, eMMC ok, http://ix.io/1fZT
* Kernel config update, enabling HDMI on CT+
* Trying to fix A64 HDMI but failed. Fixed M64 ethernet instead
* Update orangepioneplus.wip
* Update orangepioneplus.wip
* Fix H6 build process
* Add regulator bits for Orangepizero+, thanks to @5kft
* add H5 support for optional 1.3v regulator and 1.3GHz operation
This patch adds two optional overlays that can be used to:
1) enable the 1.1v/1.3v regulator on boards that provide the necessary compatible H/W support
2) modify the default CPU clock operating table to add new 1.2GHz and 1.3GHz clocks
Note that the generated regulator overlay will only support boards whose 1.1v/1.3v regulator
is controlled by GPIO PL6.
* updates for the NanoPi NEO Plus2
This change introduces a patch that provides two changes for the NanoPi NEO Plus2:
* Configure the "cpu0" to use the "vdd_cpux" regulator; this enables the ability to use higher CPU clocks
* Correct the configurations of the on-board power and status LEDs
* Adjust nightly building and few boards config cleanup
This will build IEEE 802.15.4 radio support as modules with 6LOWPAN support and
support for the following hardware:
- Atmel AT86RF23x
- Microchip MRF24J40
- TI CC2520
- ATUSB
- Analog ADF7242
- Cascoda CA8210
